15. Push down on the roof tonneau to close and latch
it. It will fit together with the boot cover to form one
continuous panel as it did in the upright position.
16. Using the release tool for the convertible top, hook
the tool into the red loop.
17. Once the roof tonneau is closed and latched, adjust
the cables located behind the seats. Pull the cable
with the red band until both cables are the same
length. Repeat this step on the other side.
18. Check the roof tonneau to make sure it is secure
before driving.
Vehicle Personalization
Memory Seat
Your vehicle may have a memory driver’s seat. The
controls for this feature are located on the outboard side
of the driver’s seat and are used to program and
recall memory settings for the driver’s seating positions.
Boot cover panel down, roof tonneau up
2-59
To Next Page
Loading...
