Tire Inflator Kit Storage
The tire inflator kit is stored behind the driver’s seat
in your vehicle. To reinstall the kit after use, do
the following:
{CAUTION:
Storing the tire inflator kit or other equipment in
the passenger compartment of the vehicle could
cause injury. In a sudden stop or collision,
loose equipment could strike someone. Store
the tire inflator kit in the proper place.
1. Place the air compressor pump and accessories
into the inflator kit case.
2. Move the driver’s seat forward and tilt the seatback
forward out of the way.
3. Place the inflator kit in its original position.
4. Place the cover over the tire inflator kit.
5. Hold the kit with the cover on against the back wall
of the passenger compartment in the designated
storage area as you perform the next step.
6. Reinstall the two nuts holding the tire inflator kit
cover in place.
Air Compressor
The air compressor included in the tire inflator kit
was designed exclusively for your vehicle. After the
sealant has been injected into the flat tire, use the air
compressor to inflate the flat tire.
A. Inflating Hose
B. Air Pressure Gage
C. ON/OFF Switch
D. Air Compressor Plug
5-70
To Next Page
Loading...
