3. Slide the endcap rearward to remove it. 4. Insert the cover into the floor track and slide it all
the way forward.
5. Reinstall the floor track fastener and endcap by
reversing Steps 2 and 3.
6. Slide the floor track cover rearward until it rests
against the endcap.
7. Repeat the above steps to install a cover for the
other floor track.
To remove the floor track covers, reverse the installation
procedure.
Additional cargo strips are installed by attaching them to
the Velcro
®
strips located in the carpeted cargo area.
2-41
To Next Page
Loading...
