Getting to Know Your Monte Carlo
8
The heated front seat controls are locat-
ed on the instrument panel with the cli-
mate controls. The seats feature a high
and low heat setting.
High: Press the button once to turn on
the heated seat. It will heat to the high
setting (two indicator lights).
Low: Press the button again to turn on
the seat to the low setting (one indicator
light).
Off: Press the button a third time to turn
off the heated seat.
See Section 1 of your Owner Manual.
Heated Seats (if equipped)
Adjust the lumbar support using the lum-
bar handle located on the outboard side
of the driver’s seat. Ratchet the handle
up to increase support and down to
decrease support.
See Section 1 of your Owner Manual.
Lumbar Adjustment
(if equipped)
To adjust the driver’s power seat, use
the power seat control located on the
outboard side of the seat.
Forward/Rearward: Move the control
forward or rearward to move the seat
forward or rearward.
Seat Cushion Tilt: Move the front or
rear of the control up or down to raise or
lower the front or rear of the seat cushion.
Adjust Seatback: Lift the recline lever
and then adjust the position of the
seatback. Release the lever to lock the
seatback in place.
See Section 1 of your Owner Manual.
Power Seat Controls
COMFORT
To Next Page
Loading...
