4. Pull the bulb assembly down to access the
bulbs.
5. Remove the bulb by pulling it straight out.
6. Install a new bulb.
7. Align the tabs in the bulb assembly with the
assembly in the trunk lid. Push the bulb
assembly back into place until it snaps in. You
may need to use a tool to guide the tabs
into the assembly.
Taillamps and Turn Signal Lamps
(Coupe)
To replace this bulb, do the following:
1. Open the trunk. See Trunk on page 100 for
more information.
2. Remove the fastener which holds down the
trunk trim.
3. Disconnect the wiring harness by lifting up on
the tab to release and pull it straight out.
4. Remove the taillamp bulb socket from the
assembly by turning it counterclockwise.
329
To Next Page
Loading...
