2. Using the flat end of the wheel wrench, pry
along the edge of the wheel cover until it
comes off.
3. Use the wheel wrench to loosen all the wheel
nuts. Do not remove them yet.
4. It is recommended that you do a safety check
before preceding. See Changing a Flat Tire
on page 355 for more information.
Notice: Make sure that the jack lift head is in
the correct position or you may damage
your vehicle. The repairs would not be covered
by your warranty.
5. Position the jack lift head at the jack location
nearest the flat tire. The front location is about
8 inches (20 cm) behind the front wheel
opening. The rear location is about 4 inches
(10 cm) in front of the rear wheel opening.
361
To Next Page
Loading...
