3. Using the flat end of the wheel wrench, pry along
the edge of the rear wheel cover until it comes off.
Store the wheel cover in the trunk until the flat
tire is repaired or replaced.
4. Use the wheel wrench to loosen all the rear wheel
nuts. Do not remove them yet.
Notice: Make sure that the jack lift head is in the
correct position or you may damage your vehicle.
The repairs would not be covered by your warranty.
5. Position the jack lift head at the rear jack location
nearest the rear tire. The rear location is about
4 inches (10 cm) in front of the rear wheel opening.
6. Raise the jack head until it fits firmly in the
vehicle’s frame, where the notch is located,
nearest the flat tire.
5-81
To Next Page
Loading...
