10-58 Vehicle Care
4. Attach the air only hose (10) to
the sealant canister inlet
valve (1) by turning it clockwise
until tight.
5. Slide the base of the tire sealant
canister (3) into the slot on the
top of the compressor (6) to hold
it upright.
Make sure the tire valve stem is
positioned close to the ground
so the hose will reach it.
6. Remove the valve stem cap from
the flat tire by turning it
counterclockwise.
7. Attach the sealant/air hose (2) to
the tire valve stem by turning it
clockwise until tight.
To Next Page
Loading...
