Chevrolet Express 2025 - Remote Start

Chevrolet Express Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18528029) - 2025
10 Keys, Doors, and Windows
Caution (Continued)
To prevent damage, always follow the
steps for RKE transmitter reassembly in this
manual to ensure the transmitter is sealed
properly whenever the RKE transmitter
is opened.
Replace the battery if the Driver Information
Cen
ter displays REPLACE BATTERY IN
REMOTE KEY.
To replace the battery:
1. S
eparate the transmitter with aflat, thin
object, such as aflat head screwdriver.
•
Car
efully insert the tool into the
notch located along the parting line
of the transmitter. Do not insert the
tool too far. Stop as soon as resistance
is felt.
•
Twist the tool until the transmitter
is separated.
2. Remove the old battery. Do not use
ametal object.
3. Insert the new battery, positive side
facing down. Replace with aCR2032 or
equivalent battery.
4. Set transmitter button side down on a hard
surface and press the other half straight
down to force the halves together.
Remote Start
This vehicle may have aremote start feature.
This feature allows you to start the engine
from outside the vehicle. It may also start the
vehicle's heating or air conditioning systems.
See Climate Control Systems 3109.
Laws in some local communities may restrict
the use of remote starters. For example, some
laws may require aperson using remote start
to have the vehicle in view when doing so.
Che
ck local regulations for any requirements
on remote starting of vehicles.
Do not use the remote start feature if the
vehicle is low on fuel. The vehicle may run out
of fuel.
The RKE transmitter range may be less while
the vehicle is running.
Other conditions can affect the performance of
the transmitter. See Remote Keyless Entry (RKE)
System 38.
/ : This button will be on the RKE transmitter
if the vehicle has remote start.
To start the engine using the remote
start feature:
1.
Press and release Q on the transmitter.
2.
Immediately press and hold / until the
turn signal lamps flash. If you cannot see
the lamps, press and hold / for at least
four seconds.
When the engine starts, the parking lamps
will turn on and remain on while the engine
is running. The doors will be locked.