3-4 Seats and Restraints
Bench Seat
To adjust the seat:
1. Move the lever to the right to
unlock the seat.
2. Slide the seat to the desired
position and release the lever.
3. Try to move the seat back and
forth to make sure it is locked
into place.
Folding the Bench Seat
To fold the bench seat:
1. Push back on the front of the
seatback.
2. Pull one of the release levers, at
each end of the seat on the
lower rear of the seatback,
completely out.
3. While holding the lever out, fold
the seatback forward until it
rests on the seat.
4. Release the lever.
Do not try to release the
seatback before pulling the
release levers or the release
system can be damaged.
{
WARNING
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
To Next Page
Loading...
Need help?
General
