Vehicle care 185
Centre high-mounted
brake light
<Bulb type>
1. Open the tailgate.
2. Remove the two screws and the
lamp housing. Disconnect the
wiring harness connector before
removing the lamp housing.
3. Remove the two screws and the
reflector assembly.
4. Remove the bulb by pulling it
straight out of the bulb holder.
5. Install a new bulb.
6. Reinstall the lamp housing.
<LED type>
Have bulbs replaced by a workshop.
Number plate light
1. Unscrew both screws.
2. Remove bulb housing downward,
taking care not to pull on the
cable.
Rotate bulb holder anti-clockwise
to disengage.
3. Remove bulb from holder and
renew bulb.
4. Insert bulb holder in bulb housing
and rotate clockwise.
5. Insert bulb housing and secure
using a screwdriver.
Interior lights
Courtesy lights
1. To remove it, prise the opposite
side of the light switch using a flat-
blade screwdriver. (Be careful not
to make scratches.)
2. Remove the bulb.
3. Replace the bulb.
4. Reinstall the light assembly.
To Next Page
Loading...
