5-7
9. Don’t let the other end
touch anything until the
next step. The other end
of the negative (
-) cable
doesn’t go to the dead
battery. It goes to a
heavy, unpainted metal
engine part or to a
remote negative (
-)
terminal on the vehicle
with the dead battery.
Connect the other end of the negative (
-) cable at
least 18 inches (45 cm) away from the dead battery,
but not near engine parts that move. The electrical
connection is just as good there, but the chance of
sparks getting back to the battery is much less.
10. Now start the vehicle with the good battery and
run the engine for a while.
11. Try to start the vehicle with the dead battery.
If it won’t start after a few tries, it probably
needs service.
NOTICE:
Damage to your vehicle may result from electrical
shorting if jumper cables are removed incorrectly.
To prevent electrical shorting, take care that
the cables don’t touch each other or any other
metal. The repairs wouldn’t be covered by
your warranty.
To Next Page
Loading...
