b) Transportation
When the goods arrive, first check for any damage. If some damage observed, immediately
contact the transport company and inform about the damage. Contact STOEWER for the
damage and do not start to install the unit until it is agreed that the damage has no affect of
operation.
Use the supplied eyebolts or lifting holes for lifting up the gear unit. The eyebolts are
capable to carry the weight of gearboxes only. Do not hang additional loads.
c) Storage
If the geared unit or gearedmotor will be stored up to 3 years refer to the following instruc-
tions;
With Packing;
-Use corrosion protection oil for the output shaft and connection surfaces like flange surface
or foot assembling surface. Seal the unit in a plastic wrap and pack it in container.Amoisture
indicator should be placed around the container to observe the moisture. Relative atmos-
pheric humidity should not exceed 50%. The container should be kept under roof which
protects from snow and rain. Under this condition the gear unit can be stored up to 3 year
with regular check.
Without Packing;
-Use protectionoilfor the output shaft and connectionsurfaces like flangesurface or foot
assembling surface. If no packing is used and the gearbox is stored without packing, the
ambient temperature should be between 5 to 60 Celsius degrees. The gearboxmust be kept
under enclosed roof with constant temperature and constant humidity not exceeding 50%.
The storage should be free of dust and dirt and ventilated with filter. If the gearbox is stored
without packing it is recommended not to store more than 2 years and regular check during
this time is recommended.
If stored in open protect against insect damage.
26
C - SERIE BETRIEBE- UND wARTUNGSANLEITUNG
CHM - SERIE BETRIEBE- UND wARTUNGSANLEITUNG
Installing
Danger!
To prevent injury, the danger area must be generously cordoned off. Standing under the
gear unit during transport is extremely dangerous.
Attention!
Avoid damage to the gear unit. Impacts to the free ends of the shafts may cause internal
damage to the gear unit.
Use adequately dimensioned and suitable means of transportation. Lifting tackle must be
designed for the weight of the gear unit. The weight of the gear unit can be obtained from the
dispatch documents.
Stöwer Antriebstechnik GmbH, Enneststrasse 3, 51702 Bergneustadt, Tel. 02261-40970, Fax: 41309, www.stoewer-getriebe.de
To Next Page
Loading...
Need help?
General