11
walls, where strings, curtains or
other objects could be used by the
child to climb or causing chocking
or strangling hazards.
• Do not place the chair near windows
or walls to prevent the risk for the
child of overreaching and falling over.
• Keep the product out of children’s
reach when it is not being used.
• Do not place the reclined cradle
with the child near windows or
walls, where strings, curtains or
other objects could be used by the
child to climb or causing chocking
or strangling hazards.
• Do not place the chair near windows
or walls to prevent the risk for the
child of overreaching and falling over.
• Keep the product out of children’s
reach when it is not being used.
CARE AND MAINTENANCE
FABRIC COMPOSITION
COVER
Outer cover: 100% polyester. Padding: 100% polyester.
• This product requires periodical maintenance.
• The cleaning and maintenance operations must only be carried
out by an adult.
• Periodically inspect the reclined cradle to check for broken, torn or
missing parts: If this is the case, do not use it.
• Please refer to the care label for instructions on cleaning the prod-
uct.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
• Check that the fabric and stitching are in good condition each time
you wash it.
• Prolonged exposure to direct sunlight can cause the fabric to fade.
To prevent friction from compromising the correct functioning of
the product, make sure that dust and dirt is removed from all mov-
ing parts.
CARRY BAG: 100% polypropylene
Components
Structure:
A1 – Base
A2 – Feet
A3 – Tubular seat elements
A4 – Backrest
A5 – Open/close buttons
A6 – Open/close junctions
A7 – Recline levers
A8 – Fitting for fabric
Padding:
B1 – Seat
B2 – Safety harness
B3 – Click buttons
B4 – Rigid trim for insertion of fabric
B5 - Seat buttonhole
C – Carry bag
OPENING THE RECLINED CRADLE
The reclined cradle comes already assembled. To use it, the follow-
ing operations must be performed:
- Remove the reclined cradle from carry bag C (Fig.1); during the
opening phase pay attention to the moving parts.
- Take the tubular elements of the seat (A3) and pull outwards (Fig. 2).
- Open fully by pulling the junctions (A6) until they click, checking
that they are rmly in place (Fig. 3).
At this point you can choose the setting you prefer.
- To adjust the angle of the backrest take the two recline levers (A7)
at the same time and pull them upwards (Fig. 4); you can choose
from one of the three possible positions (Fig. 5-6-7). To complete
the operation, release the two levers (A7). This operation may also
be carried out with the child sitting in the reclined cradle.
In this case it can be more dicult.
WARNING: Always guide the backrest (A4) with your ngers when
adjusting the recline angle.
WARNING: Always check that the backrest is properly locked be-
fore use.
FIXED OR ROCKING MODE
The reclined cradle can be used in xed or rocking mode:
- Fixed mode: turn the two feet (A2) towards the back of the reclined
cradle until the bottom of each foot touches the ground (Fig. 8).
- Rocking mode: turn the feet (A2) in opposite directions, so that the
feet are not touching the ground.
USING THE SAFETY HARNESS
- The safety harness is pre-tted and ready for use the rst time you
use the reclined cradle (Fig. 9).
- To release it, press the toothed ends of the clasp and remove the
two clasps (Fig. 10). The reclined cradle is ready for the child.
WARNING: When using, always fasten the belt by passing it
through the crotch strap and check it is tight enough and in the
right position.
It is possible to alter the tightness of the belt by adjusting it and pass-
ing the strap around the back of the backrest.
- Hold one end of the clasp in place and simultaneously pull the
belt and slide it through the relative ring to adjust the tension of
the safety harness.
CLOSING THE RECLINED CRADLE
- The reclined cradle can be closed for transportation.
- During the closing phase pay attention to the moving parts.
WARNING: The reclined cradle must never be closed with the child
sitting in it. Remove the child from the reclined cradle before closing
the frame!
To close the reclined cradle:
- Completely recline the backrest (A4) according to the indications
in the paragraph “ADJUSTING THE BACKREST” (Fig. 4).
- Press the 2 closing buttons (A5) and push the junctions (A6) to-
wards the centre of the structure (Fig. 11).
- To further compact the structure, push the tubular elements of the
seat (A3) towards each other until the reclined cradle is completely
closed (Fig. 12).
To reopen the reclined cradle follow the operations indicated in the
• Always use the restraint system
when the child is in the reclined
cradle; adjust the length of the
straps as necessary.
• WARNING: The reclined cradle
does not replace a bed or a crib.
If the child needs to sleep, then it
should be put in a bed or crib.
• WARNING: Do not use the re-
clined cradle if any components
are broken or missing.
• WARNING: Do not use accessories or
replacement parts other than those
approved by the manufacturer.
• The product and all of its compo-
nents must always be assembled by
an adult.
• Do not use the reclined cradle with
more than one child at time.
• Never leave the chair on surfaces
that are not perfectly horizontal.
• Always supervise children playing
near the reclined cradle.
• To prevent re hazards, do not leave
the reclined cradle near sources of
heat, electrical and gas devices, etc.
• Make sure that the cover is properly
secured to the structure of the chair.
• Never use it to carry your child in
motor vehicles.
• WARNING: Remove the child from
the reclined cradle before trans-
porting.
• Make sure that all parts are correct-
ly hooked to the mounts.
• Periodically check for any worn
parts, loose screws, worn or un-
stitched materials and replace any
damaged parts immediately.
• Do not place the reclined cradle
with the child near windows or
To Next Page
Loading...
