15
partisbroken,tornormissing.
•Do not use accessories or replacement
parts other than those approved by the
manufacturer.
•Never use the chair mounted seat on
brokenorunstablechairs,foldingchairs,
rockingchairsorchairswitharmrests.
•Donotusethethechairmountedseatfor
morethanonechildatatime.
•Before fastening the chair mounted
seatseattothechair,alwayscheckthat
the floor and chair seat are perfectly
horizontal; never install the product on
chairswhicharepositionedonasloping
surface.
•Donotletotherchildrenplayunattended
nearthechairmountedseat.
•Donotinstalltheproductonhighchairs.
•Donotusetheproducttotransportthe
childinthecar.
•Itisdangeroustousethisproductonan
elevatedsurface.
•Do not leave on chair mounted seat
small objects that can be swallowed by
children.
•Donotusethechairmountedseatinthe
vicinityofcurtaincords,windowsorheat
sources.
•Neverusetheproductasaswimmingaid
orfloatingchairinaswimmingpool.
•Do not use the chair mounted seat
positioneddirectlyonthefloor.
•Prolonged exposure to direct sunlight
may cause the fabric to fade. After
prolonged exposure of the cot to high
temperatures,waitafewminutesbefore
placingthechildintoit.
•Whennotinuse,thechairmountedseat
mustbekeptoutofthereachofchildren.
•Opening,adjustingandclosingoperations
of the booster seat must be carried out
exclusivelybyanadult.
• WARNING: when opening and closing,
makesurethechildisatasafedistance.
During adjusting operations, make sure
themovingpartsoftheboosterseatdo
not come into contact with the child’s
body.
• WARNING: the use of the waist safety
beltswithfabriccrotchstrapisessential
toensureyourchild’ssafety.
• WARNING: the tray alone does not
guarantee the safe containment of the
child.Alwaysusethesafetybelts!
•Donotopenandclosetheboosterseat
whenthechildissittingonit.
ADVICE FOR CLEANING AND MAINTENANCE:
Cleaning and maintenance operations must be carried
exclusivelybyanadult.
Checkthebooster seat on aregular basis forany cracks,
damage or missing parts; if anything is visible or not
workingcorrectlydonotusetheseat.
Cleantheplasticpartswithawaterdampenedcloth.
Thetraycanbewashedinthedishwasher.
INSTALLATION:
1.Unhookthelowerfasteningstrapsasshowninfigure1;
2.Detachthetrayfromtheboosterseat,bypullingoutwards
ontherelativesidehandles,asshowninfigure2;
3.Liftthebackrestasshowninfigure3andlockitinthe
vertical position (you will hear a ‘’click’’ indicating the
rightpositionhasbeenreached).
4.Theboosterseatcanbeadjustedto3differentheights;
toraisetheseatheight,afterremovingthechildfromthe
boosterseat,grasptheseatandpullitupward,making
suretoactascounter-weight,grabbingoneofthefront
feet(figure5).Youwillheara''click''ateachposition,to
confirm the properlocking of theseat at the required
height.
To lower the height, press and slightly pull forward the
buttonlocatedundertheseatasshowninfigure6.
WARNING: Always perform these operations after
removingthechildfromtheboosterseat.
5.Position the seat on the chair (figure 7); to use this
product, the chair should have the minimum sizes
indicated in figure 8. Attach the rear fastening straps,
bypassingthembehindthechair'sbackrest,asshown
in figure 9, and the lower fastening straps around the
seatasshowninfigure10;makesuretoheara"Click",to
indicatetheproperlocking.
Pullthefreeendofthelowerandrearstrapstoadjustthe
length,untiltheyareproperlypulledtightandtheseatis
securelyanchoredtothechair(figure11).
6.Oncetheboosterseatisfastenedsecurelytothechair’s
seat and backrest, youcan place your child in to it as
follows:
a.Unfastenthebuckleofthethree-pointsafetybeltsas
indicatedinfigure12A.
b.Positionthechildontheboosterseat,fasteningthem
in with the safety belts. Check that the belts and
bucklearefastenedproperly(figure12B).
7.Attached the tray to the booster seat side supports,
pullingoutwardsonthe relativesidehandles, securing
it through the central fastening buttons located on
bothsidesoftheboosterseat(seefigure13A/13B).The
stabilisers present tothe sidesof the central fastening
buttonareusedtostabilisethetray;makesurethatthe
trayisfastenedtothecentralfasteningbuttoninatleast
onepoint,andnever just to the stabilisers only (figure
13C). Thetray can be adjusted in 3 different positions
(figure13D).
FOLDING AND TRANSPORT
8.Detach the tray, pulling outwards on the relative side
handlesasexplainedinpoint2.
9.Adjust the seat bringing it to the lowest point, as
explainedinpoint4.
10.Pressthebackrest’slockingbuttonslocatedonthearms
oftheboosterseatatthesametime,andpullthearms
forwarduntilthebackrestiscompletelyfolded(figure14).
11.Securethetraytothebuttons,positioningitasshown
infigure15,inordertomaketheproductascompact
aspossiblefortransport.
12.Fasten the lower fastening straps, passing them over
thetrayasshowninfigure16.
13.Itis possible toconveniently transportthe seat using
therearstrapsasshowninfigure17.Todoso,adjust
thelength of the straps, asneeded. Alternatively,use
thetransporthandlelocatedontherearsideoftheseat
(figure18).
WARRANTY
Theproductisguaranteedagainstanyconformitydefectin
normalconditionsofuseasprovidedforbytheinstructions.
Thewarrantyshallnotthereforeapplyinthecaseofdamage
causedbyimproperuse,wearoraccidentalevents.
For the duration of the warranty on conformity defects
pleaserefertothespecificprovisionsofapplicablenational
lawsinthecountryofpurchase,whereappropriate.