1
FCC Information
www.chiccousa.com
A.
B.
RainbowCubeisaprojectorthatallowsuserstochoosetheirfavoritecolors,shapesandinwhichdirectionthey
aretobeprojected.
Turning the Toy ON/OFF:
A. To turn the toy “ON”, move the switch from position “O” (Off) to position “I” or “II” Play Mode. Select the
music and light effects mode by moving the switch to position “I“ or select the lights effects only mode by moving
the switch to position “II”.
B. Once the play mode has been selected, press the musical note button to start the toy. The musical selection in-
cludesamixofclassicaltunes,newagetracksandnaturesounds.Note:Thelighteffectsarebestwhentheroom
is completely dark. The Toy will play for 20 minutes, then switch to stand-by mode. To restart or pause the lights
and music, press the musical note button again. Always switch off the toy when it is not being used. Turn off the
toy by moving the switch to the “O” OFF position.
TheProjectionColors/ShapeModes:
C.SelectingColors:Turnthehalf-circledialswitchtooneofthe7colorsortotherainboweffectsymbol(*)to
projecttheselectedcolorwithintheroom.WhentheRainboweffectisselected,thetoywillautomaticallyproject
all 7 colors alternately (yellow, orange, pink, red, violet, blue and green).
D.SelectingProjectionand/orNightLightMode:Turntheswitchwiththesymbolofthe3projectioneffectsand
night light to start the selected light effects. Simply rotate the cube to select the direction in which you want the
lighttobeprojectedtocreateconstantlynewandcolorfulatmospheresintheroom.
C.
D.
Caution:changesormodicationsnotexpresslyapprovedbythe
partresponsibleforcompliancecouldvoidtheuser’sauthorityto
operate the equipment.
NOTE: This equipment has been tested and found to comply
withthelimitsforaClassBdigitaldevice,pursuanttoPart15of
theFCCRules.Theselimitsaredesignedtoprovidereasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connecttheequipmentintoanoutletonacircuitdifferentfrom
that to which the receiver is connected.
-Consultthedealerorexperiencedradio/TVtechnicianforhelp.