CHIEF Air Jack - Lifting and Elevating Procedure; Deflating the Air Jack

CHIEF AIR JACK
USERS MANUAL
2
4. To use the air jack, position both hands on handle
assembly. Press ‘green’ arrow (right side arrow - see
Figure 5) and inflate bag slightly to engage lift pad
with lifting point on structural component.
WARNING! Lift load from lift pad only. Lifting from
top plate will damage air jackand cre-
ate an unsafe condition.
5. Press ‘green’ arrow again to elevate structural com-
ponent to desired height.
WARNING! • DO NOT lift higher than needed.
• DO NOT over inflate.
6. To deflate the air jack, push the ‘red’ arrow.
NOTE: If the air hose has been removed from the air
jack, press either the ‘red’ or ‘green’ arrow to
deflate.
Figure 5
Green
Arrow
‘Up’
Red
Arrow
‘Down’