Chris-Craft 307-Q User Manual

6
3
0
adjustment is made by backing off the adjusting nut (rocker arm stud
nut) until there
is play in the valve push rod and then tightened to just remove
ail push rod to rocker arm clearance. This may be determined by rotating push
rod with fingers
a5 the nut is tightened. When rod does not readily move in
relation to the rocker arm, the clearance ha5 been eliminated. The adjusting
nut should then be tightened an additional 1 turn to place the hydraulic lifter
plunger in the center of its travel, No further adjustment is required.
With the engine in the number 8 firing position as determined above, the
following valves may be adjusted.
3074-327Q-3504 exhaust 8-6-54 intake 8-7-4-2
I 307QL-327QL-350QL exhaust 2-4-74! intake 1-5-6-8
Crarik the engine one revolution. This is number 3 firing position. With the
engine in this position. the following valves may be adjusted.
307Q-327Q - 3504 exhaust 7-4-3-2 intake 6-5-3-1
307Qt-327QL -350 Qt exfaa~st 1-3-56 intake 2-3-4-7
Q
I

Chris-Craft 307-Q Specifications

General

Brand	Chris-Craft
Model	307-Q
Category	Engine
Language	English