Chrysler 1991 - INSTRUMENT PANEL AND GAUGES; OVERDRIVE LOCKOUT SWITCH

•
INSTRUMENT PANEL AND GAUGES 8E - 1
INSTRUMENT PANEL AND GAUGES
OWERDRIWE LOCKOUT SWITCH
REMOVAL
(1) Locate bracket holding chime module and inter-
mittent wipe module (Fig. 2).
(2) Remove 2 nuts holding bracket to instrument
panel support.
(3) Remove ground straps and bracket.
(4) Depress lock tabs on switch and push it out of
the instrument panel.
INSTALLATION
(1) Hold wiring connector in switch opening.
(2) Push switch on to wiring connector.
(3) Continue to push until switch snaps into place.
(4) Install bracket with modules. Be sure ground
straps are installed.
GROUND
COMBINATION
BUZZER
J918E-37
Fig. 1 Overdrive Lockout Switch Location
INTERMITTENT
WIPER MODULE
BRACKET
INTERMITTENT WIPER
CONTROL MODULE
J918E-36
Fig. 2 Intermittent Wiper Module Bracket