Backup Lamps
1. Open the trunk and gently pull back the trunk liner
behind the tail lamp.
2. Remove the two plastic wing nuts from the tail lamp
housing.
3. Grasp the tail lamp and pull firmly outward pushing
on the studs from inside to disengage the lamp housing.
NOTE: Placing a small flat head screwdriver or similar
tool between the lamp outboard ball stud and plastic
grommet from inside the trunk can assist in lamp re-
moval.
4. Twist and remove socket from lamp.
5. Remove bulb from socket and replace.
450 MAINTAINING YOUR VEHICLE
To Next Page
Loading...
