(6) Remove the ignition key and remove lower col-
umn cover (Fig. 45).
(7) Remove cable from shift pin (Fig. 46).
(8) Remove cable retainer clip from shift cable con-
duit bracket (Fig. 46).
CAUTION: Column must be tilted fully upward to
remove cable retainer clip.
(9) Raise hood. From inside the engine compart-
ment, remove the gear shift cable from the cable
bracket (Fig. 47).
(10) Unseat the cable grommet from the firewall
(Fig. 49) and pull the shift cable from the interior of
the vehicle.
(11) Raise vehicle on hoist and unbolt fill tube
bracket. Rotate fill tube to gain access to the inte-
grated shift cable clamp.
(12) Disconnect cable from routing bracket as
shown in (Fig. 48).
(13) Remove shift cable retaining nut and slide
cable assy. off of mounting stud (Fig. 49).
(14) Disconnect shifter cable from shift lever
assembly at transaxle (Fig. 49).
(15) Remove cable from vehicle.
Fig. 42 Lower Column Cover Screw Removal/
Installation
1 – LOWER COLUMN COVER
2 – STEERING WHEEL
Fig. 43 Upper Column Removal/Installation
1 – STEERING WHEEL
2 – UPPER COLUMN COVER
3 – GEAR SHIFT HANDLE
Fig. 44 Tilt Lever Screw Removal/Installation
1 – STEERING WHEEL
2 – TURN SIGNAL LEVER
3 – TILT LEVER
4 – SCREWDRIVER
Fig. 45 Lower Column Cover Removal/Installation
1 – LOWER COLUMN COVER
21 - 34 42LE TRANSAXLE LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
