Chrysler 2000 LHS - Page 1206

(8) Raise hood. Remove gearshift cable from throt-
tle/gearshift cable bracket (Fig. 55)
(9) Unseat cable grommet at firewall and remove
cable from interior of vehicle (Fig. 56).
(10) Raise vehicle on hoist and disconnect fill tube
bracket from transaxle. Rotate fill tube to gain access
to shift cable clamp.
(11) Remove cable from routing bracket (Fig. 57).
(12) Remove cable-to-transaxle nut and slide cable
off of stud (Fig. 56).
(13) Disconnect shifter cable from shift lever
assembly at transaxle (Fig. 56).
(14) Remove cable from underneath vehicle.
Fig. 53 Shift Cable Adjust Lever Nut
1 – CONSOLE
2 – ACCESS HOLE
3 – SHIFTER HANDLE
Fig. 54 Floor Gearshift Cable Removal/Installation
1 – CUP
2 – CABLE
3 – CONDUIT BRACKET
4 – PIN
Fig. 55 Throttle/Gearshift Cable Bracket
1 – CABLE BRACKET
2 – GEARSHIFT CABLE
3 – THROTTLE CABLE
Fig. 56 Gearshift Cable Removal/Installation
1 – CABLE
2 – FIREWALL
3 – WASHER
4 – SHIFT LEVER
5 – NUT
6 – STUD
LH 42LE TRANSAXLE 21 - 37
REMOVAL AND INSTALLATION (Continued)