(3) Install the retainer clip until it snaps into
place in the slot cut into the shift lever mounting
stud (Fig. 74).
(4) Verify the BTSI solenoid is locked in place and
will not slide off the mounting stud.
(5) Connect the wiring harness connector to the
BTSI solenoid.
(6) Verify the BTSI is operating properly. With the
ignition on (engine not running) and the parking
brake applied, try shifting the transmission shift
lever out of the PARK position with and without the
brake pedal being applied. The shift lever should
Fig. 70 Solenoid Connector
1 – BTSI SOLENOID
2 – CONNECTOR
Fig. 71 Solenoid Retainer Clip Removal
1 – SOLENOID
2 – MOUNTING STUD
3 – RETAINER CLIP
Fig. 72 Flat Inside BTSI Solenoid
1 – GUIDES
2 – SOLENOID
3 – FLAT
Fig. 73 Guide And Flange Alignment
1 – BRACKET FLANGE
2 – GUIDE
Fig. 74 Solenoid Retainer Clip Installation
1 – SOLENOID
2 – MOUNTING STUD
3 – RETAINER CLIP
21 - 42 42LE TRANSAXLE LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
