and Operation to determine intended operation. If
adjustment is necessary, refer to Adjustments.
(13) Install the bezel on the shifter console.
(14) Install gearshift knob (Fig. 75).
(15) Install upper and lower covers from the steer-
ing column (Fig. 77).
(16) Install tilt lever (Fig. 79).
(17) Install the lower silencer panel (Fig. 76).
TRANSMISSION RANGE SENSOR
REMOVAL
(1) Disconnect the TRS connector.
(2) Remove valve body assembly from vehicle.
Refer to Valve Body removal and Installation in this
group.
(3) Remove the manual shaft seal (Fig. 85).
(4) Remove manual shaft/TRS retaining screw
(Fig. 86).
(5) Slide TRS off of manual valve shaft.
INSTALLATION
(1) Install the TRS to the manual shaft. Make sure
TRS locating pin rests in manual valve bore slot.
Fig. 82 Interlock Cable Locking Tab
1–TAB
2 – INTERLOCK CABLE
3 – LOCK CYLINDER HOUSING
Fig. 83 Interlock Cable Removal/Installation
1 – LOCK CYLINDER HOUSING
2 – INTERLOCK CABLE
Fig. 84 Ignition Key/Switch Positions
1 – ACC
2 – LOCK
3 – OFF
4 – ON/RUN
5–START
Fig. 85 Manual Shaft Seal—Typical
1 – SEAL
2 – MANUAL SHAFT
LH 42LE TRANSAXLE 21 - 45
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
