Chrysler 2000 LHS - Page 1216

REMOVAL
(1) Disconnect the output speed sensor connector
(Fig. 89).
(2) Unscrew and remove the output speed sensor.
(3) Inpsect the speed sensor o-ring and replace if
necessary (Fig. 90).
INSTALLATION
(1) Verify o-ring is installed into position (Fig. 90).
(2) Install and tighten output speed sensor to 27
N·m (20 ft. lbs.) torque.
(3) Connect speed sensor connector (Fig. 89).
(4) Connect battery negative cable.
TRANSMISSION CONTROL MODULE
REMOVAL
(1) Remove speed control servo (three fasteners).
(2) Remove windshield washer reservoir fill tube
fastener.
(3) Remove one nut and screw holding transmis-
sion control module bracket to vehicle.
(4) Lift control module and bracket to gain access
to 60-way connector.
(5) Loosen 60-way connector retaining screw,
located in the center of the 60 way connector. Then
disconnect the 60-way connector on transmission con-
trol module.
(6) Remove transmission control module mounting
screws and lift module from vehicle (Fig. 91).
INSTALLATION
(1) Install transmission control module and tighten
mounting screws.
(2) Install 60 way connector. Tighten 60-way
retaining screw to 4 N·m (35 in. lbs.).
(3) Install one nut and screw holding transmission
control module bracket to vehicle (Fig. 91). Torque
screw to 6 N·m (45 in. lbs.). Torque nut to 12 N·m
(107 in. lbs.) torque.
(4) Install windshield washer reservoir fill tube
fastener.
(5) Install speed control servo (three fasteners).
Fig. 89 Speed Sensor/Connector Location
1 – MANUAL SHIFT LEVER
2 – OUTPUT SPEED SENSOR
3 – LONG STUB SHAFT
4 – INPUT SPEED SENSOR
Fig. 90 O-Ring Location
1 – OUTPUT SPEED SENSOR
2 – O-RING
Fig. 91 Transmission Control Module (TCM)—
Removal/Installation
1 – RADIATOR UPPER SUPPORT
2 – TCM
LH 42LE TRANSAXLE 21 - 47
REMOVAL AND INSTALLATION (Continued)