(36) Remove connector on top of transaxle for sole-
noid pack.
(37) The transaxle can now be lowered from the
vehicle.
INSTALLATION
(1) When installing transaxle, reverse the above
procedure.
CAUTION: To prevent damage to the structural col-
lar, hand tighten all fasteners. This will ensure that
the collar is flush against transmission and oil pan
before torquing to specifications.
(2) If the torque converter is being replaced, apply
a light coating of grease to the crankshaft pilot hole.
(3) Inspect the drive plate for cracks before rein-
stalling transaxle. If any cracks are found replace the
drive plate. Do not attempt to repair a cracked drive
plate.
CAUTION: The bolts for the torque converter are a
new short-headed design. Bolts from previous year
vehicles cannot be used.
(4) Always use new torque converter to drive plate
bolts.
NOTE: If the transaxle assembly, TCM, solenoid
pack or clutch plates have been replaced, refer to
Quick Learn Procedure. This program will allow the
transmission control module to compensate for any
parts replaced in the electronic transaxle system.
(5) Check and/or adjust gearshift cable. Refer to
Shift Linkage in this section for procedure.
(6) Refill transaxle with Mopar ATF Plus 3 (Auto-
matic Transmission Fluid) Type 7176.
OIL PUMP SEAL REPLACEMENT
The transaxle must be removed from the vehicle to
replace this oil seal.
REMOVAL
(1) Remove the transaxle from the vehicle.
(2) Remove the torque converter from the tran-
saxle bellhousing.
(3) Use special tool C-3981B to remove oil pump
seal (Fig. 105).
INSTALLATION
(1) Clean and inspect oil pump seal seat. Then
install seal using special tool C-4193A (Fig. 106).
(2) Clean and inspect torque converter hub. If
nicks, scratches or hub wear are found, torque con-
verter replacement will be required.
CAUTION: If the torque converter is being replaced,
apply a light coating of grease to the crankshaft
pilot hole. Also inspect the engine drive plate for
cracks. If any cracks are found replace the drive
plate. Do not attempt to repair a cracked drive plate.
Always use new torque converter to drive plate
bolts.
(3) Apply a light film of transmission oil to the
torque converter hub and oil seal lips. Then install
torque converter into transaxle. Be sure that the hub
lugs mesh with the front pump lugs when installing.
(4) Reinstall the transaxle into the vehicle.
Fig. 105 Oil Seal Removal
1 – SPECIAL TOOL C-3981B
2 – WRENCH
Fig. 106 Oil Seal Installation
1 – TRANSAXLE BELL HOUSING
2 – SPECIAL TOOL C-4193A
3 – LONG STUB SHAFT
21 - 52 42LE TRANSAXLE LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
