Chrysler 2000 LHS - Page 1226

DISASSEMBLY AND ASSEMBLY
VALVE BODY
DISASSEMBLY
(1) Remove manual shaft seal.
(2) Remove manual shaft screw (Fig. 120).
(3) Remove Transmission Range Sensor (TRS) and
manual shaft (Fig. 121).
(4) Remove Solenoid/Pressure Switch Assembly
from valve body (Fig. 122).
(5) Remove valve body stiffener plate (Fig. 123).
(6) Invert valve body assembly and remove trans-
fer plate-to-valve body screws (Fig. 124).
(7) Remove transfer/separator plate from valve
body (Fig. 125)
(8) Remove separator plate-to-transfer plate
screws (Fig. 126).
(9) Remove separator plate from transfer plate
(Fig. 127).
(10) Remove oil screen (Fig. 128) from transfer
plate.
Fig. 120 TRS/Manual Shaft Retaining Screw
1 – SCREW
2 – TRS
Fig. 121 Manual Shaft/Rooster Comb and
Transmission Range Sensor
1 – TRANSMISSION RANGE SENSOR
2 – MANUAL SHAFT
3 – ROOSTER COMB
Fig. 122 Solenoid/Pressure Switch Assembly
Location
1 – SOLENOID PACK
2 – SOLENOID RETAINING SCREWS
Fig. 123 Stiffener Plate
1 – STIFFENER PLATE
LH 42LE TRANSAXLE 21 - 57