(17) Install the manual shaft/rooster comb and
transmission range sensor to the valve body (Fig.
153).
(18) Install the TRS/manual shaft retaining screw
(Fig. 154) and torque to 5 N·m (45 in. lbs.).
(19) Install manual shaft seal.
TRANSAXLE—DISASSEMBLY
Before disassembling transaxle, move the shift
lever clockwise as far as it will go. This should be
one position past the L position. Then remove the
shift lever.
NOTE: Tag all clutch pack assemblies, as they are
removed, for reassembly identification.
CAUTION: Do not intermix clutch discs or plates as
the unit might then fail.
Fig. 149 Install Transfer Plate to Valve Body
1 – TRANSFER PLATE
2 – VALVE BODY
Fig. 150 Install Transfer Plate-to-Valve Body Screws
1 – SCREW (24)
2 – TRANSFER PLATE
Fig. 151 Install Stiffener Plate
1 – STIFFENER PLATE
Fig. 152 Solenoid/Pressure Switch Assembly
1 – SOLENOID PACK
2 – SOLENOID RETAINING SCREWS
LH 42LE TRANSAXLE 21 - 65
DISASSEMBLY AND ASSEMBLY (Continued)
To Next Page
Loading...
