GETTING TO KNOW YOUR VEHICLE 65
Heated And Cooled Cupholders — If Equipped
Your vehicle may be equipped with heated and
cooled cupholders. The cupholders are
designed to help keep warm beverages warm
and cool beverages cool.
Heated And Cooled Cupholder Switches
Push the “Cold” symbol once to turn on the
cupholder. Push the symbol a second time to
turn the cupholder off. Push the “Hot” symbol
once to activate the cupholder. Push the symbol
a second time to turn off the cupholder.
Power Sunshade — If Equipped
Your vehicle may be equipped with a power
sunshade that will reduce the amount of
sunlight that will shine through the rear wind-
shield.
The power sunshade can be operated using the
Uconnect System.
Press the “Controls” button and then press the
“Rear Sunshade” button to raise the power
sunscreen. Press the “Rear Sunshade” button a
second time to lower the sunshade.
If the sunshade is in the raised position and the
vehicle is placed in REVERSE, the sunshade will
automatically fully lower. When the transmis-
sion is shifted out of REVERSE the sunshade will
automatically return to the fully raised position
after a brief delay.
The power sunshade can also be operated by
passengers in the rear seats. The power
sunshade switch is located on the back of the
center console between the heated seat
switches. Push the switch once to raise the
sunshade. Push the switch a second time to
lower the sunshade.
Power Sunshade Switch Behind Center Console
NOTE:
The rear sunshade control switch can be locked
out along with the rear passenger window controls
from the driver switch window lockout switch.
WARNING!
When using the cupholder in the “Hot”
position, avoid contact with the heated
portion of the cupholder in order to reduce
the possibility of burns. Persons who are
unable to feel pain to the skin because of
advanced age, chronic illness, diabetes,
spinal cord injuries, medication, exhaustion
or other physical condition must exercise
particular care in order to prevent serious
burn injury. Keep the cupholder free of debris
or stray objects when operated in the “Hot”
position.
2
20_LX_OM_ENA_GCC_t.book Page 65
To Next Page
Loading...
