SAFETY 165
Installing Child Restraints Using the Top
Tether Anchorage
Second Row Tether Attachment
1. Look behind the seating position where you plan
to install the child restraint to find the tether
anchorage. You may need to move the seat forward
to provide better access to the tether anchorage.
If there is no top tether anchorage for that seating
position, move the child restraint to another position
in the vehicle if one is available.
Top Tether Anchorage Locations — 2nd Row Bench
Top Tether Anchorage Locations — 2nd Row 8 Passenger
Top Tether Anchorage Locations — 3rd Row
2. Route the tether strap to provide the most direct path
for the strap between the anchor and the child seat.
If your vehicle is equipped with adjustable rear head
restraints, raise the head restraint, and where
possible, route the tether strap under the head
restraint and between the two posts. If not possible,
lower the head restraint and pass the tether strap
around the outboard side of the head restraint.
3. Attach the tether strap hook of the child restraint to
the top tether anchorage as shown in the diagram.
WARNING!
Do not attach a tether strap for a rear-facing car seat to any
location in front of the car seat, including the seat frame
or a tether anchorage. Only attach the tether strap of a
rear-facing car seat to the tether anchorage that is approved
for that seating position, located behind the top of the
vehicle seat. See
Ú
page 156 for the location of approved
tether anchorages in your vehicle.
6
23_RUV_OM_EN_US_t.book Page 165
To Next Page
Loading...
