34—TOROUE-FLITE TRANSMISSION
CHRYSLER SERVICE MANUAL
C-3380 with adapter C-3583, tighten to a read-
ing of 47-50 inch-pounds torque.
NOTE: This will be a true torque of 70-75 inch-
pounds which reading should be used if torque
wrench C-3380 is used without the adapter C-
3583 (as may be done if adjustment is made
with the transmission removed from the car).
Back off the adjusting screw 2*4 turns.
NOTE: To compensate for initial wear-in, the
adjustment of a new band must be
l
/i turn
tighter than the specification given.
Holding adjusting screw, tighten locknut to
35-40 foot-pounds torque.
INTERMEDIATE SUPPORT LOCATING SCREW
X CONVERTER
ONTROL VALVE
THROTTLE PRESSURE (COMPENSATED)
TEST HOLE PLUG
REGULATOR
VALVE
ADJUSTING
SCREW
FILLER TUBE
CONNECTOR
57x237A
(Right Side
of
Transmission)
b.
Low-Reverse Band (Rear)
The low-reverse band adjusting screw is located
on the right side of the transmission case (Fig.
22).
Loosen the locknut and back off approxi-
mately 5 turns. Check for freeness of adjusting
screw in transmission case.
Using wrench, Tool C-3380 with adapter C-
3583,
tighten to a reading of 47-50 inch-pounds
torque.
NOTE: This will be a true torque of 70-75 inch-
pounds which reading should be used if torque
wrench C-3380 is used without the adapter C-
3580 (as may be done if adjustment is made
with transmission removed from vehicle).
Back off adjusting screw 2% turns.
LUBRICATION PRESSURE
REAR CLUTCH APPLY PRESSURE TEST PLUG
INTERMEDIATE SUPPORT LOCATING SCREW
CARBURETOR
TO
BELL
CRANK
ROD
DASH PANEL
BELL CRANK
TO
ACCELERATOR
PEDAL
ROD
BELL CRANK
TO TRANSMISSION
ROD
TRANSMISSION THROTTLE
VALVE LEVER
58x63
Fig.
21—Throttle Linkage Adjustments
GOVERNOR
PRESSURE
TAKE-OFF PLUG
NEUTRAL STARTER SWITCH
KICKDOWN BAND ADJUSTING SCREW
LINE PRESSURE TAKE-OFF PLUG
56 x
684C
Fig.
22—Transmission Case
(Left Side
of
Transmission)
NOTE: To compensate for initial wear-in, the
adjustment of a new band must be ^4 turn
tighter than the specification given.
Holding adjusting screw, tighten locknut to
35-40 foot-pounds torque.
16.
THROTTLE LINKAGE ADJUSTMENTS
(REFER TO FIG. 21)
(FOUR BARREL CARBURETOR)
With the engine at operating temperature
and carburetor off the idle cam, adjust idle
speed to 475-500 R.P.M. (use tachometer).
Loosen the throttle linkage adjusting nuts on
the carburetor to bell crank rod, and on the
bell crank to transmission rod. Adjust carbu-
retor to bell crank rod to position the lever
Y> inch from the cowl dash panel (see "A"
MyMopar.com
To Next Page
Loading...
