40—TOROUE-FLITE TRANSMISSION
CHRYSLER SERVICE MANUAL
27.
VALVE BODIES AND TRANSFER
PLATE ASSEMBLY
a. Removal
Place push button control unit in 1 (low) posi-
tion.
NOTE;
It will be necessary for control cable
adapter to be in this position (for accessibility)
when removing cable from adapter housing on
transmission.
Remove oil pan. Disconnect throttle link from
throttle lever on transmission. Remove all dirt
and foreign material from around control cable
housing. Loosen throttle valve lever screw and
remove lever assembly. Remove flat washer and
lip seal from throttle valve lever shaft. Remove
control cable adjustable mounting bracket. Re-
move control cable adapter housing plug, insert
screw driver through hole, and release the con-
trol cable spring lock. While exerting pressure
on control cable spring lock, remove cable (Fig.
27).
Using same screw driver, insert through
cable opening in adapter housing and push lever
rearward to last detent. Reinstall housing plug
and tighten.
Remove the three control cable housing
screws and washers. Remove control cable
housing and gasket. Loosen manual valve con-
trol lever screw and slide lever off shaft. Re-
move the four oil strainer assembly screws
and washers and remove oil strainer assembly.
Loosen (to relieve spring load) and remove the
three accumulator cover screws with washers.
VALVE BODIES AND
TRANSFER PLATE
ASSEMBLIES
x660A
CONTROL CABLE ADAPTER^
Q;4M^p.SPRING LOCK
"
L
"^MANUAL VALVE
Fig.
29—Removal and Installation of Valve Bodies
and Transfer Plate Assembly
56x658
Fig.
30—Setting Manual Valve Control
Lever Clearance
Remove cover and spring from transfer plate.
Remove the three transfer plate screws and
washers and remove valve bodies and transfer
plate assembly from transmission case (Fig.
29).
b.
Installation
Clean mating surfaces and check for burrs on
both the transmission case and valve body
transfer plate. Install valve bodies and transfer
plate assembly on transmission case. Install the
three transfer plate screws and washers (two
in center and one on front). Draw down evenly
and tighten to specifications.
CAUTION
Dished type washers are used to prevent cutting
or chipping of soft metals and should be in-
stalled on screws with dished portion facing
away from head.
Install accumulator spring through transfer
plate and position in piston. Install accumula-
tor cover, three screws, and washers; draw
down evenly. Place oil strainer in position on
transfer plate assembly. Install the four screws
and washers. Draw down evenly and tighten
strainer and accumulator cover screws to speci-
fications. Install oil pan. Install manual valve
control lever (locking screw to rear) on manual
valve lever shaft. Position lever on shaft so
there is %
2
" clearance (without gasket) be-
tween lever and transmission case.
NOTE:
a 7/32" drill bit can be used for obtain-
MyMopar.com
To Next Page
Loading...
