CHRYSLER SERVICE MANUAL
TOROUE-FLITE TRANSMISSION—47
CONTROL CABLE
ADAPTER
HOUSING
MANUAL VAL
CONTROL LEVE
ACCUMULATOR COVER
-SPRING
56x601
Fig.
37—Removal and Installation of Control
Cable Adapter Housing
37.
VALVE BODIES AND TRANSFER
PLATE—REMOVAL
Remove throttle valve lever, flat washer, and
lip seal. Remove the three gearshift control
cable adapter housing bolts and washers. Re-
move housing and gasket from transmission,
as shown in Figure 37. Manual valve control
lever must be moved to the reverse position
before housing can be removed. Loosen man-
ual valve control lever bolt. Using caution to
prevent loss of cable adapter pin, slide lever
and cable adapter off shaft.
Remove four oil strainer assembly bolts and
lock washers. Remove oil strainer assembly,
as shown in Figure 38. Loosen (to relieve
spring load) the three accumulator cover bolts
with washers, and remove cover and spring
from transfer plate, as shown in Figure 39.
Remove three transfer plate bolts and washers.
Remove valve bodies and transfer plate assem-
bly from transmission case, as shown in Fig-
ure 40. Mating surfaces are machined: use ex-
treme care so as not to damage these surfaces.
Place valve body in stand, Tool C-3528. Remove
the neutral starting switch (with cupped wash-
OIL STRAINER
Fig.
39—Removal and Installation
of Accumulator Cover
er and "0" ring) located in left side of trans-
mission case as shown in Figure 22. ;
38.
CHECKING FRONT CLUTCH
END CLEARANCE
Prior to removal of propeller shaft flange and
drum assembly, check end clearance of front
clutch piston retainer assembly using dial in-
dicator Tool C-3339, as shown in Figure 41.
To make this check, move front clutch for-
ward by pulling on the input shaft, or by care-
fully inserting screw driver and prying be-
tween the front and rear clutches. Remove
screw driver, and with dial indicator point
contacting edge of front clutch retainer, set
dial indicator to zero. Push clutch assembly
57x233
Fig.
38—Removing Oil Strainer Assembly
56x604
Fig.
40—Removal and Installation of Valve Bodies
and Transfer Plate Assembly (Typical View)
MyMopar.com
To Next Page
Loading...
