80—TORQUE-FLITE TRANSMISSION
CHRYSLER SERVICE MANUAL
ing away from valve body (to allow maximum
travel of lever). While holding levers in posi-
tion in valve body with rubber band, install
shaft snap ring (V). Remove rubber band.
With reverse blocker valve spring in position
in valve (0) and with slots in valve aligned
with pin, install reverse blocker valve in valve
body. Install reverse blocker valve plug (N)
and compress spring sufficiently to install pin
(M).
Lock pin in position. Check kickdown
detent plug stop screw for being tight. Install
detent plug (larger inner diameter first) on
kickdown valve (J) and position kickdown
valve (detent plug first) into valve body.
Install throttle valve spring (I) and throttle
valve (H) into valve body. Install shuttle valve
(G) and spring (F) in the valve body. Install
plug (E) into position in valve body. Place
front check valve ball (D) and seat (C) in
position in valve body.
NOTE:
Ball seat must have smooth side
(rounded edge) towards ball.
Place shuttle valve cover (B) in position on
valve body and install four bolts and lockwash-
ers.
Draw down evenly.
129.
VALVE BODY PLATE (UPPER)—
INSTALLATION
Place valve body transfer plate in an upright
position on fixture Tool C-3528. Place steel plate
(upper) over pilots on Tool C-3528, and into
position on transfer plate.
132.
FRONT VALVE BODY—INSTALLATION
Position front valve body on steel plate (up-
per),
as shown in Figure 106, and install two
bolts and lockwashers in outer end of valve
and draw down finger tight.
VALVE BODY
RETAINER PLATE
TOOL
56x672
Fig.
114—Tightening Valve Body Screws
130.
REAR VALVE BODY—INSTALLATION
Invert transfer plate assembly and replace on
fixture, Tool C-3528. With servo pressure bleed
valve in place, hold rear valve body up into
position against steel plate, as shown in Figure
105,
and install the two outer bolts (short)
with lockwashers through the transfer plate
and into lower valve body. Draw up finger
tight.
131.
LOWER VALVE BODY—INSTALLATION
Position steel plate (lower) on lower valve
body. Place valve body and steel plate into posi-
tion on transfer plate. Install the two bolts
(intermediate length) and lockwashers, and
tighten the two lower valve body and two rear
valve body bolts to specifications.
Invert valve bodies and transfer plate and
replace on fixture Tool C-3528. Install valve
TRANSFER PLATE ASSY.
FRONT VALVE BODY ASSY.
VALVE BODY RETAINER PLATE
REAR VALVE
BODY ASSY.
MANUAL VALVE
LOWER VALVE
BODY ASSY.
56x666A
56x67iA
Fig.
113—Installation of Valve Body Retainer Plate
Fig.
115—Valve Bodies and Transfer Plate Assembly
(Bottom View)
MyMopar.com
To Next Page
Loading...
