22—BODY AND SHEET METAL
CHRYSLER SERVICE MANUAL
57x763
Fig.
52—Replacing Glass Run Channel
Disengage the glass run channel from the
window frame and remove the frame.
NOTE: The glass run channel is cemented to
the lower ends of the glass run.
b.
Installation
Carefully center the door window frame
through the top opening in door and install the
attaching screws "A," "B," "C," "D" and "F,"
but do not tighten screws at this time.
Install screws "R" and engage glass run
channel in the window frame. Tighten the
frame attaching screws securely and check op-
eration of window. Check the window frame
alignment with the door opening.
57x768
Fig.
54—Installing Glass Run Channel
Install the frame bolt moulding "S" and re-
cement the upper weatherstrip to the door. In-
stall the water curtain and repair any damage.
Install the trim panel and garnish moulding.
c. Adjustments
Refer to Figure 51 (57x656) and proceed as
follows: Loosen frame mounting bolts "A,"
"B,"
"C," "D" and "F." Loosen the division bar
mounting bolt "E."
Push the frame IN or OUT as necessary for
a good fit around the window opening. Tighten
all mounting bolts, except division bar bolt "E,"
and check the fit of the frame.
Run the glass UP and DOWN. To relieve a
i mm
GLASS FRAME ATTACHING BOLTS
57x7641
Fig.
53—Removing Glass Run Channel
57x71.6*
Fig.
55—Removing and Installing Adjusting Frame
and Glass Assembly
MyMopar.com
To Next Page
Loading...
