CHRYSLER SERVICE MANUAL
BODY
AND
SHEET METAL—23
binding condition at the lower end of the divi-
sion bar, shim between the bar and its bracket
until a smooth operation is made.
NOTE:
On Imperial models, an adjusting bolt
is provided on the lower end of the division bar
for IN or OUT adjustment.
19.
REPLACING GLASS RUN CHANNEL
(Cars without Removable Frame Assembly)
Work lower portion of door trim panel away
from door to facilitate disengaging lower end
of channel from support. Lower door window
and loosen garnish moulding screws and dis-
engage upper section of channel, as shown in
Figure 52. Disengage end of glass run from
ventilation window division bar, and pull the
glass run channel down from top. Pull remain-
ing portion of run up and out of door, as shown
in Figure 53.
When installing new glass run channel, use
old run as pattern for length and curved por-
tion.
Install by sliding vertical length into door
to the curve (see Fig. 54) and across top. En-
gage with ventilator window division bar, raise
door window glass, and engage lower end of
run in channel. Tighten garnish moulding
screws and reinstall trim panel and arm rest
assembly.
NOTE:
To replace glass run channel, front
ventilator assembly and window glass, refer to
Figure 55. Remove frame to door attaching
screws and frame and glass assembly.
"C"
UPPER PIVOT
TO GLASS SCREW
"B"
VENTILATOR
TO
DOOR MOUNTING
BOLT
"D"
LOWER PIVOT
AND SPRING
Fig.
56—Removing Ventilator
Fig.
57—Removing
or
Installing Glass Frame
and Door Ventilator
20.
REMOVAL AND INSTALLATION OF DOOR
VENTILATOR ASSEMBLY (Cars with
Removable Glass Frame Assembly)
Remove garnish moulding, remote control han-
dles,
arm rest (if so equipped), and door trim
panel. Remove screws that attach ventilator
window to door frame, as shown in Figure 56.
One screw is on front face of door. Remove
bolt holding division bar (anchor) of ventila-
tor window to inside door panel. Lower front
door window glass against its bottom stop.
Slightly twist ventilator window and, at same
time,
tilt it toward inside of car to disengage
lowered door window glass from division bar
run.
Slide ventilator window up and out of
door panel, as shown in Figure 57.
When installing ventilator window, engage
door glass with division bar as outlined in the
removal procedure. After installing ventilator
assembly, check door window glass for opera-
tion and adjust as needed.
NOTE:
Care should be taken to align glass
frame assembly to roofline and door opening
(Fig. 15). Check door for proper sealing (Fig.
16).
21. REMOVAL AND INSTALLATION OF DOOR
GLASS (Cars without Removable Door
Glass Frame Assembly)
Remove garnish moulding, inside door handles,
arm rest, and trim panel assembly. Remove
trim panel and weatherproof liner. Avoid dam-
MyMopar.com
To Next Page
Loading...
