24—BODY AND SHEET METAL
CHRYSLER SERVICE MANUAL
aging liner. Remove glass run and screws that
hold lower window stop to door panel and re-
move stop.
Lower window far enough to facilitate dis-
engagement of regulator arm pivot roller. Raise
window and tilt glass inward until glass clears
to raise window until the other regulator arm
pivot roller clears door. Disengage pivot arm
and remove window glass.
When installing new window glass, be sure
that slots in bottom of channel frame are coated
liberally with lubriplate and that the pivot
rollers are free. After installing window glass,
adjust division bar so that the vertical sliding
glass does not bind when window is raised or
lowered. Align door glass and frame assembly
and check door seal as indicated in Paragraph
3 (Fig. 15 and 16).
22.
REMOVAL AND INSTALLATION OF DOOR
LATCH AND REMOTE CONTROL (Fig. 58)
Remove garnish-moulding, trim panel and arm
rest assembly, and remote control handles. Re-
move screws holding remote control base to
door panel. Raise window and bend bottom
catch of window felt run channel outward
(toward center of door). Work door latch and
remote control assembly out through opening
in door.
When installing remote control assembly,
coat all parts liberally with lubriplate. Install
assembly through opening in door and secure
with attaching screws. Bend bottom catch of
window felt run channel inward and install cap
screws holding remote control base to door
panel. Check the assembly for proper opera-
tion. Install trim panel, garnish moulding, and
door handles.
23.
REMOVAL AND INSTALLATION OF
QUARTER WINDOW GLASS (Special Club
Coupe and Convertible Coupe Models)
a. Special Club Coupe
Refer to Figure 58 and proceed as follows:
Remove rear seat cushion, regulator handle,
and trim panels. Lower glass and remove Al-
len screw locking pivot arm pin. Pull forward
vertical section of felt run channel up and out
of body opening. Carefully raise glass and dis-
connect regulator arm from quarter glass low-
er channel. Remove glass from opening. If glass
is to be replaced, drive the seal and channel
off glass with hardwood block and mallet.
LOCK LOCKING
CONTROL
ASSEMBLY
DOOR
LOCK RFMOTE
CONTROL ASSEMBLY
DIVISION
BAR
LINK
UP
STOP ADJUSTING SCREWS
REAR
UP-STOP BRACKET
REGULATOR
MOUNTING
|
BOLTS)
:
>.«BBIREGUIATOR
ELECTRIC
m
WINDOW)
pf
-
DOWN-STOP
ADJUSTING SCREWS
DOWN-STOP mm%
ADJUSTING SCREWS
$.
DIVISION
BAR
ADJUSTING
^M (IN OR OUT
MOVEMENT)
DOOR
LOCK REMOTE
CONTROL ASSEMBLY
Fig.
58—Front
and
Rear Door Control
Assembly
MyMopar.com
To Next Page
Loading...
