CHRYSLER SERVICE MANUAL
BODY AND SHEET METAL—27
Fig.
65—Removing or Installing Lower Side Moulding
moulding from "A" post. Remove windshield
header trim and garnish moulding from weath-
erstrip.
a. Removing Mouldings
Protect hood and other necessary components
of car with protective covering to avoid dam-
aging finish. Remove "A" post side moulding
(Fig. 64) attaching screws. Avoid damaging
door-to-"A" post seal. Remove lower mouldings,
as shown in Figure 65, lift upper horizontal
moulding out of weatherstrip. Remove wind-
shield wiper blades. Remove lower horizontal
moulding clips and mouldings. (Fig. 66).
On Imperial Models, remove "A" post side
mouldings and upper and lower moulding re-
taining clips, as shown in Figure 67, and re-
move horizontal mouldings. Remove moulding
retaining screws, as shown in Figure 68. Re-
move head lining and remove upper moulding
attaching screws and moulding (Fig. 69).
Fig.
67—Removing or Installing Upper and Lower
Moulding Clips (Imperial Models)
57x720
Fig.
68—Removing or Installing Moulding Retaining
Screws (Imperial Models)
b.
Removal and Installation of
Windshield Glass
Unlock weatherstrip with wedge, as shown in
Figure 70, (all around windshield). When re-
moving glass from weatherstrip, it may be nec-
essary to wear gloves to protect hands. With
helper assisting on outside of car, remove glass
[57x6091
Fig. 66—
Removing or Installing Horizontal Moulding
Fig.
69—Removing or Installing Upper Windshield
Moulding (Imperial Models)
MyMopar.com
To Next Page
Loading...
