Chrysler Windsor C-71 1956 - Floor Panel; Town and Country Wagon (Sealing)

64—BODY AND SHEET METAL
CHRYSLER SERVICE MANUAL
LICENSE PLATE INSERT
DECK LID-
58x114
Fig. 137—License Frame Mounting
On Chrysler models, a leak at the fuel filler
outer housing may be corrected by packing body
caulking putty around the fuel filler tube hous-
ing flange under the fuel filler door on the rear
quarter (Fig. 140). Seal around the housing
flange reinforcement inside the rear quarter
panel by packing with body caulking putty. Seal
around the fuel filler tube housing at the lug-
gage compartment floor.
47. FLOOR PANEL
Before correcting water and dust leaks at the
floor panel, be sure to determine the exact
source of the leak. Be sure all under body plugs
are in the floor panel. Be sure all door sill drain
openings are open. (Often undercoating closes
off these openings.)
Using liquid body sealer, reseal all joint
seams of the floor, the luggage compartment
floor, the quarter extension panels and all excess
opening covers (Fig. 141). Seal the floor panel
to cowl panel joint seams, floor panel to side sill
joint seams, the floor panel joint over the rear
axle kick-up, and the floor panel to wheel hous-
ing joint seams.
48. TOWN AND COUNTRY WAGON
Sealing procedures pertaining to the roof, cowl,
firewall, fresh ir vent, doors and openings are
essentially the same as contained in the section
INSERT - SPARE WHEEL
DECK PANEL
COVER - SPARE WHEEL
58x115
Fig. 138—Spare Tire Carrier (Imperial Models)
MyMopar.com