66—BODY AND SHEET METAL
CHRYSLER SERVICE MANUAL
devoted to sedans and coupe models. Body fea-
tures that are pertinent to Town and Country
Wagon bodies are contained in this section.
49.
REAR FLOOR PAN (At Rear)
Seal around the entire periphery of the brace
with black semi-fluid sealer or body caulking
putty, as indicated in Figure 142 (1) to elim-
inate dust and carbon monoxide penetrations.
Apply sealer to the seam between the reinforce-
ment lower tail gate opening panel and rear
floor pan side extention as indicated at (2).
Install tape over hole in brace as indicated
in (3). Press additional sealer into seams from
under body.
50.
REAR FLOOR PAN (At Front)
Apply black semi-fluid sealer to seams as in-
dicated in Figure 143 (1) and (2). It will be
necessary to reach through the access hole at
the rear seat back filler, as shown in Figure
143 in order to seal (2).
51.
REAR PILLARS
Water may leak into improperly sealed seams
in the rear body upper pillar and work down
the pillar into the interior of the body, also
check for skips in the sealer around the quar-
ter window opening mouldings. Press body
sealer into the seam around the upper finish
moulding cap as indicated in Figure 144 (1).
Wipe off surplus and match color of paint.
Water may also be rammed into the front
corers of the rear pillars around the quarter
glass weatherseal. Force sealer around the
weatherstrip and into the corners. Clean off
surplus sealer.
(EXCEPT SURBURBAN)
LOCK PILLAR
REAR FLOOR PAN
FRONT FLOOR
(EXCEPT SURBURBAN)
BODY REAR LOCK PILLAR TO WHEELHOUSE BRACE
FLOOR PAN INSERT
APPLY SEALER THRU
ACCESS HOLE
SIDE SILL OUTER
REAR SEAT RISER
SIDE SILL INNER
SIX WAY SEAT ONLY
SPEC.
CL. CPE. &
CONV. CPE.
(IMPERIAL)
58x118
Fig.
141—Floor Panel Assembly
MyMopar.com
To Next Page
Loading...
