CHRYSLER SERVICE MANUAL
BODY
AND
SHEET METAL—77
TORSION RODS
(UPPER
AND
LOWER)
Fig.
153—Tail Gate Torsion Bars Installed
hinge
to
tail gate. Install tail gate
and
hinges
as
an
assembly.
d.
Removal
of
Door Latch
Remove glass
run
channel. Remove three
at-
taching screws
and
door latch. When installing
door latch make sure
it is
properly aligned with
striker.
(Fig. 152)
e.
Replace Door Latch Pull Wire
Remove inner panel
and
replace wires.
To ad-
just length
of
latch pull wire, loosen screw
holding adjusting bracket (located under inner
lip
of
door inner panel)
and
place wire
in
proper groove
to
apply tension. Tighten screws.
f.
Removal Upper Glass
Run
Channel
Remove attaching screws
and pry out
channel
from retaining strip.
70.
REMOVAL
AND
INSTALLATION
OF
REAR
QUARTER WINDOW
Remove rear quarter window garnish mould-
ing attaching screws
and
remove garnish
moulding. Exert pressure
on the
outside
of
glass
and
carefully force
it out of
opening.
Before installing
the
rear quarter window
glass,
remove
old
sealer from weatherstrip
and
window frame. Apply
a
bead
of new
sealer
all
around window opening. Install glass
in the
weatherstrip
and
insert pull cord
in
sealing
lip slot,
as
shown
in
Figure
154. The
pull cord
should
be
installed
so
ends
of
cord
are on bot-
tom
and
outside
of
vehicle.
Slide window glass
and
weatherstrip into
position
in
window opening. Press glass firmly
to compress
the
sealing bead. Install garnish
moulding
and
attaching screws.
Do not
tighten
screws. Pull cord
and
position sealing
lip
over
edge
of
window reveal,
as
shown
in
Figure
149.
If pull cord
is not
available,
a
wood
or
fiber
wedge
can be
used
to
position
lip of
weather-
strip,
as
shown
in
Figure
154.
Tighten garnish
moulding attaching screws securely.
71.
SPARE TIRE MOUNTING
Spare tire assembly
is
located
in the
right rear
fender.
(Fig. 155) To
remove tire
and
wheel
assembly,
the
fender skirt
and
wheel clamp
must
be
removed.
72.
INSTRUMENT PANEL
AND
BODY
WIRING ASSEMBLY
For body wiring diagrams refer
to
Figures
156
through
157.
t"'
•
1
t>';\^
-k
:
h?
Fig.
154—Removing Pull Cord from
Weatherstrip
57*752
Fig.
155-Spare Wheel Mounting (Typical)
MyMopar.com
To Next Page
Loading...
