1. Find a flat surface and lay parts 1, 2 & 3 as shown,
ensuring that the cup holders on both side panels
are facing inwards. Insert 4 screws through the
back panel (part 3) where the arrows show and
screw them into both side panels. Once
assembled stand up the arbour assembly.
2. Next insert the seat ( part 4) When inserting the
seat if you find It is a little bit tight just pull the
side panels out a little bit at the front, then lower
the seat unit onto the ledges on each side panel.
Screw the seat unit in to place.
Using 2 screws, screw into the seat at an angle on
each side, as indicated by the arrows (right)
Using 2 more screws, screw through each side of
the side panel into the seat. As indicated (below)
To Next Page
Loading...