Chyo MJ-3000 - Balance Installation Guide; Unpacking, Placement, and Connection

INSTALLATION:
1. Check the shipping box fer the proper acces-
sories. See the packing list for correct items.
2. Select the proper location for the balance
according to the PRECAUTIONS Section of this
manual.
3. Remove the shipping cover utilizing a "Phillips"
type screw driver.
4.lnsert the weighing pan holder.
5.Carefully place the weighing pan into the holder.
6. Set the level of the balance by adiusting the
serew feet and aligning the bubble in the spirit
level into the center circule.
7. A ttach the AC adapter cord to the balance and
plug into power source. (Make certain the
power source is grounded l
8. The stand-by indicator on the display will
appear. Allow the balance to warm up for
30
minutes before calibrating.
ABBREVIATED INSTRUCTIONS:
1.Place the balance on a level surface free from vibration and drafts. Check the spirit level and adiust
the leveling feet if necessary.
2.Attach AC Adapter cord and then allow counting display "9999999 to CXXJOOOO". Press the Ü'J/STBY
key and wait 30 minutes to allow the balance to warm up.
3. Calibration .
.. ·Make certain 011air shield doors (if air shield case attached) are c10sed and the weighing pan
is empty .
.. ·Select the CAL program in furiction menu, and follow the pre-programmed steps .
... The display reads "PASS" when the calibration is complete.
4. Simple weighing
.. ·Press the TARE key .
.. ·Place a sample in center of the weighing pan .
.. ·C1ose air shield doors. (if air shield case attached)
... Allow reading to stabilize.
-3-