Do you have a question about the Cicognani 6v6 Amp JAZZ & BLUES and is the answer not in the manual?
Tubes (power) | 2 x 6V6 |
---|---|
Channels | 1 |
Type | Tube Amplifier |
Tubes (preamp) | 1 x 12AX7 |
Controls | Volume, Tone |
Inputs | 1 x 1/4" |
Outputs | 1 x 1/4" (Speaker Out) |
Ensure correct power supply voltage and grounding for safe operation.
Verify CE conformity and protect equipment from weather.
Periodically check cables and refer to service for repairs.
Turn on the amplifier and wait 60 seconds for valves to pre-heat.
Use high-quality shielded cables for guitar connection.
Use the Standby switch for short breaks to prolong valve life.
Turn off the Standby switch first, then the Power switch.
Details input impedance, channel levels, and preamp tube types.
Covers power output, frequency response, and power tube types.
Includes dimensions, weight, and power supply details.
Guidelines for safely replacing power and preamp tubes.
Describes the default tube setup for single-coil pickups.
Suggests alternative tubes for humbucker pickups for cleaner sound.
Details the sonic characteristics of 6V6EH and 12AX7WC tubes.
Explains the role of the preamp stage in tone and signal/noise ratio.
Connect guitar, adjust sensitivity/saturation, and control volume/gain boost.
Adjust EQ, presence, and master volume for desired sound.
Manage amplifier power states for operation and standby.
Connects to mains power and houses the fuse for protection.
Ports for footswitch, effects loop, and external speaker/amplifier connections.
Explains the effects loop and the integrated fet buffer.
Describes connecting effects in parallel for sound mixing.
Details connecting effects in series for full signal processing.
Illustrates mono and stereo jack plug configurations.
Diagram showing the typical signal flow from guitar to speaker.
Recommended settings for a clean, acoustic-like tone.
Suggested settings for a funky, mid-focused tone.
Settings for warm, classic blues and jazz tones.
Recommended settings for a rock-infused blues sound.