How do I install Cielo Smart Thermostat with a C-wire?
Installing Cielo Smart Thermostat with a C-wire
Tools you need:
- Drill for mounting anchors (3/16” drill bit)
- Small flathead screwdriver
- Phillips screwdriver
- Wire stripper (optional)
- Hammer (optional)
- Pencil (optional)
Step 1: Power off your HVAC system using the:
1. The master switch OR 2. The circuit breaker
Step 2: To be on the safe side, ensure that your system is completely switched off.
Double-check that:
1. No air is coming out of air vents
To Next Page
Need help?
General