Cifarelli S.p.A - Italy
Page 22
P
P
R
R
O
O
C
C
E
E
D
D
U
U
R
R
E
E
F
F
O
O
R
R
F
F
L
L
O
O
O
O
D
D
E
E
D
D
E
E
N
N
G
G
I
I
N
N
E
E
If the engine floods, please proceed as it follows:
Unscrew and remove spark plug (Picture 1 pos. 3), wipe and dry it.
Verify that the choke lever B is in horizontal position as shown in the Picture 14.
Pull the starting handle (Picture 1 pos.4) at least 20 times.
Mount the spark-plug; accelerate to the maximum using the steady throttle lever
(Picture 10 pos.4).
Start the engine.
In case the engine doesn’t start, please act as follows:
Unscrew and remove spark plug, wipe and dry it.
Turn the engine upside-down in order to have the hole of the spark-plug
downwards.
Pull the starting handle (Picture 1 pos.4) at least 20 times and check if the fuel
pours out the spark-plug hole.
Dry the outside around the centre spark plug.
Assemble the spark plug and repeat starting procedure keeping the gas lever
at maximum position and the choke lever B in horizontal position ( Picture 14).
Picture 16 - Position of the spark plug
WARNING
Don’t waste the fuel in the environment. If possible, collect it in a suitable
container.
When the spark-plug is connected to the cap, it emits high-voltage
current, which can be dangerous especially for people with pacemakers
or heart diseases.
Several pulls for starting the engine are very tiring. So please rest
between several starting pulls.
To Next Page