Cimel CE318-T Quick Setup Guide

12. After a “GOSUN” scenario rotate the base of the robot
until the sun spot lines up to the target. The sun spot may
not be centered on the target but should be closer than
4mm. If the sun spot is further, go back to step 6.
13. Tighten the bolts on the robot base to secure the robot
without changing its position.
Important note: watch out that the level didn’t move. If the
level moved, go back to step 6 and repeat procedure.
Mounting
bolts

Cimel CE318-T Specifications

General

Brand	Cimel
Model	CE318-T
Category	Measuring Instruments
Language	English