CIOKS LINK range power supplies underneath or on top of a Pedaltrain board.
Page 5
CIOKS/Eventide PowerFactor 2
If you wish to mount the CIOKS/Eventide PowerFactor 2 underneath a Pedaltrain board, the procedure is
the same as with the Link range units, you just need to drill four holes instead of three. The four needed
and included stand-offs should be attached as shown on the picture below.
On top of any Pedaltrain pedal board
If you wish to attach a link range power supply on top of your Pedaltrain pedal board, please have a look at
the following pictures, where we show the attachment of the unit in the most left top corner of a PT-Jr
board. Other positions are of course also possible, just use minimum two screws to fasten the power supply
to the board.
Prior to mounting you should remove the detachable rubber feet of the power supply. Use a template to
marks the needed two holes for mounting the power supply flush with the back of the pedal board. Drill
the holes and fasten the unit using just the screws. For top mounting you don’t need the spring washers
nor the stand-offs.
To Next Page
Loading...
