CIPTON CPTN1019 - User Manual

READ CAREFULLY AND KEEP THIS CARD
General Warnings
• Do not use in the rain, sleet or snow. Keep away from water and extreme temperatures.
• Adult supervision is required when performing any maintenance on the ball.
• The ball comes with built-in batteries which should not be disposed of with regular
household waste. Follow all local laws and regulations in disposing of batteries.
Setting Up
• The ball comes with batteries already installed. Pull the tab marked “PULL” to remove
the spacer insulating the batteries.
• To activate the lights, bounce the ball. The lights are impact-activated.
• If the spacer is broken and cannot be pulled out, or if the ball does not light up after
the spacer is removed, try following the steps in the Replacing the Batteries section
below to re-install the light unit or replace the batteries.
Replacing the Batteries
CAUTION: Do not sure a sharp tool to open the cap. It is recommended to use a key.
These procedures should be done carefully, under adult supervision ONLY.
Keep all batteries, wrenches, plastic bags and other accessories away from babies,
children and pets. They are NOT toys. They can cause injury, suocation, poisoning or
other dangers.
LED Football
CPTN1019
+
+
+
STEP 1
Deate the ball slightly and
use a non-sharp tool such as a
key to pry open the end cap.
Do not use a sharp tool as this
many damage the ball.
STEP 2
Use the hook of the tool to
pull out the light unit.
STEP 3
Pull the transparent tube
containing the batteries
out of the unit.
STEP 4
Use the tool to push the
batteries out of the unit
as shown above.
STEP 5
Insert 3 new LR44 coin cell
batteries with the positive poles
facing down. Do not mix old and
new batteries, or mix dierent
types or brands of battery.
STEP 6
Place the transparent tube
of batteries back into the
light unit.
Instructions continued on back of page

CIPTON CPTN1019 Specifications