123
Instruction Manual
SVGm
ENGLISH
3.2.- INSTALLATION LOCATION
The device must be installed in an environment where the temperature outside the cabinet is between
-10ºC and 45ºC, with a maximum humidity of 95% without condensation.
Do not install the device close to a hot spot and keep it out of direct sunlight.
Install the SVGm in a place protected from water, dust, flammable liquids, gases and
corrosive substances.
Make sure there are no power factor correction devices installed in the same mains as
the SVGm.
If there are any compensation devices, these must be detuned in order to avoid inter-
ference between them and the SVGm.
3.2.1.- VENTILATION REQUIREMENTS
Section “4.6 - THERMAL PROTECTION” describes all the thermal protections available in the device.
3.2.1.1.- Wall-type SVGm
The device has a power control system that controls the rotation speed of the fans and the maximum
power of the device according to the internal temperature, to ensure the best performance in any
condition.
Table 10: Ventilation distances: Wall-type SVGm.
Ventilation distances: Wall-type SVGm
50 mm 400 mm
3.2.1.2.- Rack-type SVGm
The Rack-type SVGm uses a forced ventilation cooling system, with an air inlet on the front panel and
an air outlet at the back of the device.
Once installed, the device’s flows of inlet air and outlet air must be allowed to circulate freely. At max-
imum power, the Rack-type SVGm circulates an airflow of 375 m
3
/h.
The device has a power control system that controls the rotation speed of the fans and the maximum
power of the device according to the internal temperature, to ensure the best performance in any
condition.
To maintain the device’s performance, we recommend ensuring that the air circulates freely through
the front panel of the Rack-type SVGm, and that the rear is free of obstacles, with a gap of at least
300 mm.
To Next Page
Loading...